Clothoid
from command line: sngDMTKlot
toolbar:
Function creates clothoid on basis of specified
parameters.
Parameters can be entered
by selecting a
segment of line and entering at least
two of the three
parameters.
Another possibility is
to select line segment and a circle
(arc). In this case, the function tries
to calculate the
remaining parameters clothoid.
Clothoid is drawn
as a 3dPolyline
with vertices of
spacing specified in
the dialogue (section Division of
arc).
The
following prompts are displayed:
Select line or
2d/3dpolyline: select line for
constructing clothoid Select circle (arc) for iteration or
press Enter to skip: select entity for iteration (not always
possible).
You can
insert table with parameters of clothoid after computing.
Sample
pictures:
|