Insert signs of
cross section to axis of profile
from
command line: sngDMTSign
toolbar:
To
generate the cross sections
must be
inserted on the axis
of the profile signs.
Sign
can be put
in 3 ways:
Pick
Interval
Stationing
The following prompts are
displayed: .
Option Pick:
Select line or
2d/3dpolyline (axes of profile):
Select triangle
mesh:
Select next triangle mesh
or ENTER to skip
Insert sign on the axis of
profile <Pick>/Interval/Stationing:
Insert sign to axis of
profile:
Left offset
<25.0>:
Right offset
<25.0>:
Option
Interval: Select line or 2d/3dpolyline (axes of
profile):
Select triangle
mesh:
None selected triangle
mesh
Insert sign on the axis of
profile <Pick>/Interval/Stationing:
Interval
<25>:
Left offset
<25.0>:
Right offset
<25.0>:
Option
Stationing:
Select line or
2d/3dpolyline (axes of profile):
Select triangle
mesh:
None selected triangle
mesh
Insert sign on the axis of
profile <Pick>/Interval/Stationing:
Stationing:
25.98
Left offset
<25.0>:
Right offset <25.0>:
Note 1 TIN selects for determining the
beginning stationing
and intervals. Axis is a
profile may start off TIN.
Note 2
The offset is entered
to determine the extent
of the cutting plane.
|